QUICK CHANGE NOSE
The R150 tool is equipped with a quick
change nose. This feature allows the user
to change the work contact element to
meet various fastening needs. The work
contact element can be changed without
the use of tools by following these steps:
Removal
1.
Remove battery from the tool !!!
2. Firmly grasp the end of the Work
Contact Element and turn it 90 degrees
3. Pull the Work Contact Element from
the tool.
Replace
1. Orient the Work Contact Element
so that the notched or flat portion is
toward the back or the tool
2. Firmly push the Work Contact Element
up into the nose piece.
3. Slightly twist the Work Contact Element
to be sure it is fully engaged in the nose.
NOTE:
There should be no open gap
between the shear block plate and the
nose piece.
4. Insert the battery and operate the tool.
Work Contact Elements
P/N: M150200 – To be used with fasteners
with pre-mounted 1/2" washers.
P/N: E150100 – To be used with straight
pins, fasteners with eyelets, and fastener
assemblies.
QUICK CHANGE NOSE
QUICK CHANGE NOSE
9
