TOOL OPERATION
DAILY FUNCTION TEST
Always check the tool first to make sure
that it does not contain a strip load or
fastener.
Test the tool several times by
depressing the muzzle bushing fully on a
hard surface and pulling the trigger. You
should hear an audible click as the firing pin
releases. Let up on the tool and check to be
sure that the barrel has opened to the full
open position.
OPERATING THE RAMSET
RA27 TOOL
1. After checking to be sure that the tool
is not loaded, point it in a safe direction
and be sure that the barrel is fully
extended. This ensures that the piston
is in position for the next fastening.
2. With finger off the trigger, place the
fastener, point out, into the muzzle
end of the tool until the point end is
inside the muzzle.
NEVER
load a
fastener with your finger on the trigger.
DO NOT
use excessive force when
inserting a fastener.
STOP
immediately
if excessive force is required, inspect
the barrel to find out why the fastener
is not entering the muzzle freely.
DO
NOT
continue loading unless the
problem is corrected.
3. With the tool pointed in a safe
direction and finger away from the
trigger, insert a load strip into the
bottom of the handle and push it in
until bottom of the strip is even with
the bottom recess in the handle.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
9
PERFORM FUNCTION TEST WITH
EMPTY, UNLOADED TOOL
BE SURE BARREL IS FULLY FORWARD
INSERT FASTENER INTO THE
MUZZLE END OF THE TOOL WITH
THE POINT OUT
INSERT LOAD STRIP INTO THE SLOTS IN
THE RECEIVER HANDLE
