SP-1
•
10
uF units used in this circuit. Simply make sure that correct polarity is
followed for all electrolytic capacitors.
17. Install C7, a .47 uF electrolytic.
18. Near the volume control, install R19, 4.7K (yellow-violet-red).
19. Install R1, 10K (brown-black-orange).
20. Near S1, install electrolytic C26, 47 uF.
21. Install R16, 100K (brown-black-yellow)
22. Install R3, 4.7K (yellow-violet-red).
At this point, we will begin installing jumper wires near parts already installed, if
you run short of useful wire lengths during assembly, simply skip that jumper
step and go back to it after you've built up your scrap wire supply. Jumpers act
as electronic "bridges" carrying signals over PC board traces underneath.
23. Near R3, install JMP11.
24. Install JMP5.
25. Install JMP7 (between R16 and S2).
26. Install C2, .47 uF electrolytic. Watch polarity.
27. Install C3, .05 or .047 uF (marked .047 or 473 or .05 or 503).
28. Install JMP6.
29. Install JMP12.
30. Install C13, .01 uF (marked .01 or 103).
31. Install R8, 820 ohms (gray-red-brown).
32. Install R4, 270 ohms (red-violet-brown).
33. Install R12, 47K (yellow-violet-orange).
34. Install C14, .01 uF (marked .01 or 103 or 10 nf).
35. Install JMP15 (near T1).
36. Install JMP18.
37. Install C10, .01 uF (marked .01 or 10 nf or 103).
38. Install R2, 1K (brown-black-red). Install the following jumpers.
39. JMP14.
