15.Place thrust washer (item #46) over end
of drum shaft and slide downward until
spacer rests on drum. Press drum down-
ward to compress springs in gear housing.
Insert keys (item #31) into keyways with
sharp edge of keys pointing outward and
notched end of keys upward. A rubber or
brass mallet will be needed to gently tap
keys into position.
Apply Mobilith SHC 007 Synthetic grease
to keys and end of shaft. place jaw clutch
(item #5) over end of shaft and slide jaw
clutch over keys.
Set clutch housing (item #9) over end of
drum shaft. Pull jaw clutch (item #5)
upward, toward clutch housing, enough to
allow yoke, in clutch housing, to fit proper-
ly in groove around jaw clutch.
16.Attach frame assembly (item
#1) using six capscrews (item
#21) with lockwashers and
two capscrews (item #20)
with lockwasher. Torque cap-
screws to 34 ft. lbs. (46 Nm.)
each. Insert plug (item #36)
into bottom of gear housing.
Permatex may be applied to
threads to help prevent leakage.
Attach adapter rod (item #26)
to clutch shaft using pin (item
#37).
Pour 3/4 pint of
Phillips SMP 80W-90,
Mobil HD 80W-90, Shell Spirax HD
80W-90 or CITGO MP 80W-90 gear oil
only
into housing through hole in top of
housing. Pipe plug (Item #35) should then
be placed into hole on top of gear housing.
Tighten securely.
14
