background image

12 

Warranty Information 

Ramsey Winches are designed and built to exacting specifications. Care and skill go into every winch we make. 
If the need should arise, warranty procedure is outlined on the back of your self-addressed, postage paid war-
ranty card. Please read and fill out the enclosed warranty card and send it to Ramsey Winch Company. If you 
have any problems with your winch, please follow instructions for prompt service on all warranty claims. 

Limited Lifetime Warranty 

Ramsey Winch offers a limited lifetime warranty for each new Ramsey 
winch against manufacturing defects in workmanship and materials on all 

manufactured components. 

Warranty registration cards for each winch must be submitted at the time 
of purchase or within 30 days. Warranty will only be valid for the original 
purchaser of the winch and installed on the vehicles with which they were 
originally registered. 

New cable assemblies are warranted against defects in workmanship and 
materials. No warranty applies after initial use.  

All Ramsey mounting kits and other accessories carry a one year limited 
warranty against defects in materials and workmanship.  

This warranty is void if winch is used in commercial/industrial applications 

other than front mount self recovery. 

Electrical components consisting of motors, solenoids, wiring, wire con-
nectors, and associated parts carry a limited 1-year warranty. Battery 
isolators carry a 90-day limited warranty. 

The obligation under this warranty, statutory or otherwise, is limited to the 

replacement or repair at the manufacturers factory, or at a point desig-
nated by the manufacturer, of such part as shall appear to the manufac-
turer, upon inspection of such part, to have been defective in material or 
workmanship. This Warranty does not obligate Ramsey Winch Company 
to bear the cost of labor or transportation charges in connection with the 
replacement or repair of defective parts, nor shall it apply to a product 

upon which repairs or alterations have been made, unless authorized by 
the manufacturer, or for equipment misused, neglected or improperly 
installed. 

Important notice: To the fullest extent permitted by applicable law, 
the following are hereby excluded and disclaimed: 1. All warranties 

of fitness for a particular purpose; 2. All warranties of merchant-
ability; 3. All claims for consequential or incidental damages. There 
are no warranties that extend beyond the description that appears 
on the face hereof. 

Some states do not allow the above exclusions or disclaimers in 

consumer transactions and as such this disclaimer/exclusion may 
not apply to your particular case. 

To the extent such warranties of fitness for a particular purpose or 
merchantability are deemed to apply to this product, they exist only 
for so long as the express limited warranty elsewhere set forth is in 
existence. 

Ramsey Winch Company makes no warranty in respect to accessories, 
same being subject to the warranties of their respective manufacturers. 

Ramsey Winch Company, whose policy is one of continuous product 
improvement, reserves the right to improve any product through changes 
in design or materials as it may deem desirable without being obligated to 

incorporate such changes in products of previous manufacture. 

If field service at the request of the buyer is rendered and the fault is found 
not to be with Ramsey Winch Company’s product, the buyer shall pay the 
time and expense of the field representative. Bills for service, labor or other 
expenses which have been incurred by the buyer without express approval 

or authorization by Ramsey Winch Company will not be accepted. 

This warranty gives you specific legal rights and you may also have other 
legal rights which vary from state to state. 

BIG FOOT TRADE

 

Almaty, KAZAKHSTAN

  PHONE 

+7

(

727

)

3903426

 • 

+7(705) 2626212

  

Visit us at http://www.

bigfoottrade.kz

 

914162-0107-D 

Инструкция RAMSEY REP 9.5e

www.bigfoottrade.kz

Summary of Contents for REP 9.5e













Reviews: