SPECIFICATIONS*
WARNINGS:
THE USER SHALL ENSURE THAT THE OPERATING PERSONNEL ARE GIVEN THE NECESSARY TRAINING.
THE OPERATOR SHALL ALWAYS WORK IN COMPLIANCE WITH THE OPERATING INSTRUCTIONS.
A MOTOR SPOOL (OPEN CENTER) DIRECTIONAL CONTROL VALVE IS REQUIRED FOR BRAKE OPERATION.
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF ROPE WHILE PULLING. DO NOT TRY TO GUIDE ROPE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PERSONNEL.
A MINIMUM OF 2 WRAPS OF ROPE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
AVOID CONDITIONS WHERE LOAD SHIFTS OR JERKS OCCUR. EXCESSIVE “INCHING” SHALL BE AVOIDED.
USER’S RESPONSIBILITY FOR CE COMPLIANCE
1.
Use only a motor spool (open center) control valve Per Hydraulic System Requirements.
2.
If a remote-operated winch control valve is used, refer to Hydraulic System Requirements for
Emergency Stop components to be installed.
3.
Adjust system relief pressure per Hydraulic System Requirements
4.
Mount winch per Winch Mounting Instructions.
5.
Install 20 mm (.787 inch), grade 1960 wire rope. Maximum rope length of 62 M (205 ft) for
four layers maximum. Attach rope to the drum per Rope Installation Instructions. Hook must
have a safety latch and a minimum breaking strength of 334 kN.
1
First Layer Line Pull
133,4 kN (30000 lb)
Noise Level
76 db
Ambient Temperature Range
-28C to 60C (-20F to 140F)
Gear Reduction
31:89:1
Weight (without rope)
261 kg (575 lb)
LAYER OF ROPE
1
2
3
4
Line pull per layer
kN
133,4
111,2
95,3
83,3
lb
30,000
24,900
21,400
18,700
* Rope Capacity per Layer
m
10
25
42
62
ft
35
85
140
205
* Line Speed at 56,7 LPM (15
GPM)
MPM
5,5
6,3
7,2
8,5
FPM
18
21
24
28
* These specifications are based on recommended 20 mm (.787") 1960 grade wire rope and a 195 cc (11.9 cu in /Rev)
motor.
Summary of Contents for RPH 133,4
Page 19: ...16...
