perform properly.
Allow 2 inches of space between the water dispenser and the wall, which allows for proper
air circulation to cool the compressor.
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not cut or
remove the third (ground) prong from the power cord under any circumstances. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized products service center.
This water dispenser is not recommended for outdoor usage.
Do not locate the dispenser in the area where the temperature may fall below freezing point
(0
℃
or 32
℉
).
Keep area around dispenser free of dust and dirt.
Keep the reserve supply of water bottles away from excessive heat and light.
PRE-OPERATION INSTRUCTIONS
Before connecting the appliance to the power source. Let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from
handling during transportation.
Check and make sure the backside hot water drainage hole cap is not leaked or broken.
The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be
flushed with fresh water before use as follows:
Keep the unit unplugged.
Fill water tank with tap water full to capacity. Wait for 5 minutes until water settles.
Push the hot water faucet until water comes out, then stop the faucet.
Plug the dispenser into the electrical outlet. We are ready to complete the first cycle. In order
to do that, wait for the hot water to reach temperature in approximately 10 minutes, and then
wait for the cold water to reach temperature in other 40 minutes approximately.
Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets
one at a time until no more water remains. (Note: To facilitate this operation, use a large
container).
Then, drain any water left in the tanks by opening the backside hot water drainage hole cap,
until all water drains completely. After that, screw up the cap tightly.
Put the bottled purified or other dean water on the top cover one minute.
Push water faucet buttons to insure water flows from both faucets.
Plug dispenser again into the electrical outlet.
Now you are ready to use your water dispenser.
NOTE:
Your water dispenser has been cleaned and sanitized before leaving the factory, but in
case a taste problem develops, place two tablespoons of baking soda and add tap water. Fill water
tank again and repeat basic operations, except turn hot water function “OFF” to avoid leaving
residues in hot water tank.
OPERATION
Ambient temperature: 10 ~ 43
℃
Atmosphere 86 ~ 106kpa
