When carrying it, the angle of inclination should be less than 45
C.
Adopt the ground wire to avoid any electric shock.
In the process of using, check the water receptacle frequently. If the water receptacle is full,
please pour the water out in time.
Do not turn on and off the “cooling” switch in three minutes to protect the compressor and
extend the compressor usage life.
MAINTENANCE
Remove power plug or disconnect from the mains before performing any maintenance or
servicing the product.
Never use detergent or chemicals harmful to health to clean the water tanks.
Do not directly spray water on the surface of the product.
Wipe the front and back of the product with water-soaked soft cloth.
If dust of other exterior substance has accumulated on the condenser, wipe off with
water-soaked soft cloth.
After cleaning the product, completely dry it. Fill the water to the tanks until waters comes
out of the hot water faucet, then connect the electric power plug. If the surface of the electric
heater in the hot water tank is deposited by water deposition, heating capacity will decrease.
Fill hot water tank with aqueous solution of 2% aitric acid and keep for about two hours then
cleaning. If the problems can not be solved, contact your dealer or the Service Center of our
company.
If power supply cord on this device is damaged, it must be replaced with a special power
supply cord that is obtainable at Service Center of our company.
TROUBLESHOOTING GUIDE
You can solve many common water dispenser problems easily, saving you the cost of a possible
service call. Try the suggestions outlined below to see if you can solve them before calling the
service center.
Problem
Possible Reason
Water dispenser does not operate.
Not plugged in.
Water dispenser is not cold enough.
Check to be sure the cold switch on the back is turned on.
The water dispenser does not have enough backside space.
Water dispenser’s hot water is not hot enough. Check to be sure the hot switch on the back is turned on.
Compressor turns on and off frequently.
The room temperature is too hot.
The water dispenser does not have enough backside space.
Vibration
Check to assure that the water cooler is placed level.
Water dispenser makes too much noise.
As each cycle ends, you may hear gurgling sound caused
by the flow of refrigerant, which is normal.
Contraction and expansion of the inside walls may cause
popping and cracking noises.
The water dispenser is not placed level.
This appliance is not intended for use by persons (including children) with reduced physical, sensory
