8
2.
≤
Remove bracket and drill holes. Drill a
13/32" hole through the top of the axle bracket
and 15/32" hole through the side.
3.
≤
Reinstall the track bar bracket and attach it
to the axle with the sleeve and hardware from
kit 860072. See Figure 8. Tighten to
specifications.
4.
≤
Insert track bar into track bar bracket and
install the 14mm hardware from kit 860072.
Do not tighten.
5.
≤
Raise the rear axle and position the track
bar into the frame bracket. Loosely install the
original hardware.
6.
≤
Bend gas tank skid plate away from track
bar if necessary.
Lower Arm Replacement
Note: Remove and replace one suspension
arm at a time.
1.
≤
Support the rear axle with a hydraulic jack.
2.
≤
Remove the lower arm axle and frame
mounting bolts. Remove the lower
suspension arm.
3.
≤
Install a new Rancho lower suspension arm,
along with four shims from kit 860070, to the
frame and axle brackets. See figure 9. Use
original hardware but do not tighten.
Figure 9
Note: Install two shims at each mounting
point, one on either side of the bushing
assembly. Also, position the arm so that the
grease fittings are accessible.
4.
≤
Repeat steps 2 and 3 for the other side.
