5
DashCam 500 User Manual
Getting Started
To begin using your DashCam, you need to:
Install the Memory Card
The DashCam records all videos and images to a
micro SD card that inserts into the side of the unit.
You must remove the plastic cover to access the
card slot.
1. On the right side of the DashCam, pull back the cover that
protects the card slot using a paper clip, fingernail, or another
thin tool.
2. Slide the card into the slot until it clicks into place.
3. Replace the cover.
4. To remove the SD card, open the cover and push down in the
center of the card’s edge. It will click and eject.
Notes:
You can only use a micro SD card. You must format the SD card before
using it. (you can do this in the camera). Refer to the
Format the Memory
Card
section.
Attach the Suction Cup and Mount to Window
The DashCam connects to a separate suction cup mount. There are two
tabs on the mount that connect into the top of the DashCam. These
tabs on the side of the mount can be squeezed to insert or release the
mount from the camera.
There is only one way the suction cup
mount can attach to the camera. Please pay attention to the
small notch near the connector pins of the suction cup mount
that aligns to a small tab on the top of the camera.
1. Press the suction cup against the windshield.
2. Rotate the knob on the mount to lock it in place.
3. On the bottom of the GPS mount, press the two tabs inward
and hold them.
4. Slide the DashCam into the mount and release the tabs.
5. Press the tabs again to release the DashCam from the mount.
1
2
3
4
➘
➘
➘
Summary of Contents for DashCam 500
Page 1: ...DashCam 500 User Manual ...
