Device Registration Instructions
Adjust the angle of the mount using the
thumbscrew. Pull the suction cup lever up to
release suction. Place and hold the mount
suction cup against the mounting surface,
then press the suction cup lever down until
it snaps into place.
Note:
Follow all local regulations governing
the placement of the mount.
Power on the device by pressing the Power
button on top.
Register the device.
Refer to the Device Registration Instructions
below.
Once the device is installed and
powered on, the Registration screen
should display. Your Customer # and
Serial # will be pre-populated on
the screen. At this time, you will
be asked to enter a Truck # – this
can be whatever number you want to
assign. Then, press Register.
Quick Diagnostics:
Verify GPS communication.
Select SysInfo icon
from Home Menu. Select Diagnostics, then the
GPS tab. Verify GPS status is good and that
there are values in the Latitude and
Longitude fields.
Verify J1708/1939 communication.
Drive the
truck at least .2 miles. Select the SysInfo
icon from Home Menu. Select Diagnostics, then
the J-Bus tab. Verify that there is an
odometer value in the Eng. odom. field. Then
go back to the Home Menu and select Stats.
icon, then the Driver Performance tab. Verify
there is a value in the Miles field on the
second line in the first column. (Enterprise
Plan only)
Send test message.
Select the Mail icon on
the Home Menu and tap Send. Type message
subject and message text, and tap Send in the
upper left hand corner. Make sure message
indicator changes from X to a green check
mark. (Basic & Enterprise Plan only)
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
