PROGRAMMING THE X2 FOOTSWITCH
Press, hold, and release channel select button to store footswitch buttons and effects to each chan-
nel. (Clean, O.D., Fry)
When using the Included MIDI foot controller, it may require reprogramming to each channel, before it will work correctly.
Please follow the list below to correctly program the X2 channels with the MIDI foot controller.
1. First connect the foot controller using the 7-Pin MIDI cable to the MIDI IN on your rear panel of the X2
2. Push button 1 on the foot controller
3. Set to Channel 1 (Clean) on the X2 (Now both the foot controller and the X2 should be on Channel 1.)
4. Press, hold, and release the Channel button on the X2 front panel for 2 seconds.
5. Next Push button 2 on the foot controller.
6. Set to Channel 2 (O.D.) on the X2 (Now both the foot controller and the X2 should be on Channel 2.)
7. Again, Press, hold, and release the Channel button on the X2 front panel for 2 seconds. Continue to repeat this
process for channels 3 (Fry). Push button 3, select to Channel 3(Fry) on the X2, push the channel button for 2 seconds.
If this process does not program the foot controller to the RM4, turn the unit off/on, and repeat the process. Please
contact our customer service dept., if you should have any questions or problems.
INPUT
Ch. Select
CLEAN CH.
GAIN 1
MASTER 1
GAIN 2
MASTER 2
Overdrive/Fry
Green/O.D.
Red/Fry
DENSITY
BASS
-
+
Flat
EQUALIZATION
Sweep
200Hz
2K
Mid Level
Mid Freq.
Treble
Presence
POWER
Press 1/Clean
Press 2/O.D.
Press 3/Fry
