29
5
)
用十字螺丝刀移除固定风机的
3
颗螺钉;
6
)
取下风机;
7
)
更换风机,逆操作完成安装。
1)move 1 screw in the front of the cover of the freezing air
duct with a cross screwdriver;
2)y up the buckles in the front and side of air duct;
3)move the fan and temperature sensor wires from the
buckles;
4)move cover at the back of the freezing air duct;
5)move 3 screws for fixing fan motor with a cross
screwdriver;
6)ke down fan motor;
7)place the fan in reverse steps.
8.5
蒸发器及感温系统
Evaporator and temperature sensing system
冷藏室内蒸发器
Evaporator in refrigeration chamber
1
)
拆下冷藏室风道组件。
2
)
断开所有接线器。
3
)
去除入口管和出口管焊接。
4
)
拆下蒸发器。
1)move the air duct components in refrigeration chamber.
2)sconnect all connectors.
3)move the welding on inlet and outlet tubes.
4)move the evaporator.
蒸发器上的部件
Components on the evaporator
化霜温控器
Defrost thermostat
None
化霜传感器
化霜传感器位于蒸发器顶部。
*
该部件不可更换。
Defrost sensor
The defrost sensor is located on top of the evaporator.
*Don’t break the welding of the evaporator in case that only
the sensor needs to be replaced.
Summary of Contents for COMBI Series
