31
在拆卸冷冻室温度传感器之前,应拆开冷冻室风道
组件。
1
)
剥去固定线束的胶带;
2
)
取下风机及风道泡沫;
3
)
拆除传感器。
All air duct components in the freezing chamber
should
be
dismantled
before
removing
the
temperature sensor in the freezing chamber.
1)rip the adhesive tape which fixes the harness.
2)ke down fan motor and air duct foam;
3)en remove the sensor.
冷藏室中的传感器
Sensor in refrigerating chamber
在拆传感器前,应先拆除冷藏室风道组件
1
)
先拆除冷藏室风道组件。
2
)
拆除传感器。
The air duct components in refrigerating chamber
should be dismantled before removing the sensor.
1)move the air duct components in refrigerating
chamber.
2)en remove the sensor.
环境温湿度传感器
Ambient temperature and humidity sensor
传感器位于左门铰链罩内,它发送温湿度信号给微
处理器。
The sensor is located in the internal hinge cover of
left door and sends temperature and humidity signal
to microprocessor.
8.7
压缩机仓
Compressor case
后盖板和压缩机仓
Rear cover and compressor case
Summary of Contents for COMBI Series
