Factory wired circuits & breaker panels
Single point main power connection to factory
wired and factory tested UL listed breaker panels.
• UL listed design eliminates untimely
inspection issues
• Reduced and controlled field installation costs
• Single floor or ceiling penetration for greater
control of cost and field issues
• Speed of installation saves time and money
• Increased safety on factory tested system and
easy-to-reach breakers
RCB 9/05
1055 Mendell Davis Drive • Jackson MS 39272
888-994-7636 • 601-372-3903 • Fax 888-864-7636
difoodservice.com
Patented drawer systems
Randell’s exclusive removable drawer cartridge
system offers maximum reliability and features
for end-users:
• All stainless steel welded construction
• Unitized cartridge is easily removable
without tools for easy cleaning and
preventative maintenance
• Quick-release and fully extendable drawer
slides allow easy removal of drawer tracks
• Variety of sizes for maximum space
• 3-years parts & labor on the entire assembly
Conductive cooling of pans
Cold-wall conductive cooling with exclusive
cold-transfer plates to maximize efficiency and
consistency of cooling pan.
Drawer cartridge system with 3-year warranty
Frost line cools surface of pans for safe food temps
Heavy-duty shelving
Overshelf designs that are strong, durable, safe
and easy to install.
• Factory assembled and welded leg design
with set-on installation
• Fully-enclosed UL listed raceways to conceal
all electrical runs and accommodate heat
lamps or other accessories
Press-fit gaskets can be cleaned or replaced easily
Strong supports
16-gauge (14-gauge available) top and
standard under shelves are supported with
heavy-gauge U-channel supports that provide
additional strength and durability.
Exclusive gaskets
Unique press-fit gasket design allows end-
users to easily remove, clean and replace
gaskets — no tools required.
Easy to clean
Randell’s exclusive standard rail/pan opening
drain and conveniently located oversized drain
line are easy to clean. Front access through
hinged louver or mechanical housing door for
easy cleaning.
• Easy access to rail/pan opening
• Easy access to on/off switch
• Easy access to thermostat
Smooth interior pan drain and over-sized rail drain
Openings are built into the top of unit as one-piece
One-piece designs
Hot food well, cold-pan and sink openings are
all integrally designed and built into the top as
one-piece, or installed from below, for the most
efficient design aesthetics and easiest to clean
work-surfaces available.
Breaker panels are factory wired and tested
Refrigeration systems
Lower compressor operating temperatures
prolong the life and efficiency of the
refrigeration. Features listed below enable
Randell systems to run 25
°
cooler.
• Fresh-air shroud enclosure assures the
freshest and coolest air is directed across the
condenser coil for optimal heat removal
• Controlled air flow of fresh air and exhausted
air improves cooling capacity and prevents
recycling of super-heated air by the compressor
• High impact ABS door openings (jambs)
provide superior durability and greater
operating efficiency while minimizing
thermal transfer and reducing sweating
(typical of steel fabricated fronts)
• Hinged louver allows access to drains for
pan rails/openings, cleaning of the coil, and
temperature control
• Increased storage capacity with factory
designed and assembled mullion coils —
increases space, improves air flow and cooling
capacity, and keeps controls and fans safe
Side-mounted air duct exhausts out the front
Optional cover
Randell’s optional hood cover design allows
easy access to the cover while managing the
ambient conditions by shrouding the cold
space with its integral enclosed design.
Optional roll cover for better cooling
Custom Fabrication. Proven Performance.
