R&G Racing
Unit 1, Shelleys Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0) 1420 89007 | Fax : +44 (0) 1420 87301 | Email: info@rg-racing.com
Hinweis für Kits mit Plastikunterlegscheiben an den Schrauben –
Diese Plastikunterlegscheiben werden
nicht für den Einbau benötigt!
SIE BENÖTIGEN FOLGENDES WERKZEUG:
3mm Inbusschlüssel
Linke Seite (in Fahrtrichtung):
Führen Sie die Halbrundkopfschraube durch den Rahmeneinsatz, sodass der Kopf in der
Gegenbohrung sitz.
Die spezielle Mutter am Ende der Schraube so anbringen, dass die abgestufte Fläche in den
gestuften Ausschnitt reinpasst.
Ziehen Sie die Schraube fest, bis die abgestufte Fläche der Mutter die gestufte Fläche des
Rahmeneinsatzes leicht berührt.
Die Einheit an der oben abgebildeten Position anbringen.
Ziehen Sie die Schraube fest, sodass der Rahmeneinsatz sicher in Position befestigt ist (nicht zu
stark anziehen).
Den Bubble-Aufkleber wie oben abgebildet anbringen.
Überprüfen Sie regelmäßig, dass der Rahmeneinsatz noch fest fixiert ist.
AUSGABE 1 NSY 14/03/2014
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not
diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or
warranty (other than as to title) has been given or will apply to the Products other than those in R&G’s order or confirmation and the Buyer confirms it
has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other
services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is
responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall
at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained
otherwise than in accordance with R&G’s or manufacturer’s instructions and good engineering practice or if the defect arises from accident or neglect.
Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or
consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These
terms do not affect the Buyer’s statutory rights.
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G
Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The
customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your
statutory rights and does not refer to faulty goods.
