LP0245
R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
11
Page | 11
ARTICLE 9 = ASSEMBLAGE FEU DE PLAQUE (LA0002) (x1).
ARTICLE 10 = 200mm LONGUEUR DE MANCHON THERMO RÉTRACTABLE (x3).
ARTICLE 11 = REFLECTEUR (REFL 1) (x1).
ARTICLE 12 = CLIPS CABLE (x4).
ARTICLE 13 = CONNECTEUR FEU DE PLAQUE (CON0007) (x1).
NOTICE DE MONTAGE
•
Pour monter le support de plaque R&G, commencez par enlever le siège à l’aide de la
clé, voir photo 1.
•
Enlever les 2 clips ‘R’ indiqués sur la photo 2 puis enlever les 2 pins indiqués sur la
photo 3.
•
Enlever cache sous plateau, voir photo 4.
•
Glisser le cache prise en caoutchouc sur le faisceau de câbles pour donner l’accès au
clignotant et au feu de plaque, voir photo 5.
•
Déconnecter les 3 prises, voir photo 6 (Clignotants et feu de plaque).
•
Enlever les 4 boulons, voir photo 7, tout en supportant le support de plaque d’origine
par le dessous.
•
Abaisser le support de plaque d’origine tout en passant le fil dans le trou du sous
plateau.
Si vous réutilisez les clignotants d’origine
•
Enlever la vis, voir photo 8.
•
Enlever le support de clignotants, voir photo 9.
•
Enlever la plaque d’écartement du clignotant, voir photo 10.
•
Tordre légèrement la tige de clignotants puis enlever le clignotant
•
Répéter les étapes supérieures pour enlever le clignotant opposé.
•
Monter les clignotants sur le nouveau support de plaque (article 1) puis serrer, voir
photos 11,12,13, et 14.
Si vous réutilisez les mini clignotants
•
Pour monter les mini clignotants R&G (mini clignotant R&G code produit
RG370 pour type ampoule et RG371 pour type LED ou RG372 pour LED
latérales).
•
Positionner les 2 adaptateurs de clignotant (article 6 –I0039) sur le fil de chaque
clignotant, en veillant à ce que les côtés qui se font face possèdent le profil
central, avant d’insérer l’écrou fourni, voir photos 15 et 16.
•
Passer le fil de clignotants dans le cache Écrou/fil (article 7), voir photos 16 et 17
(cela aide d’utiliser un peu de liquide détergent si besoin) et positionner le cache
écrou sur l’écrou.
•
Appliquer une longueur de manchon thermo rétractable (article 10) sur les fils de
chaque clignotant.
•
Monter le feu de plaque R&G (article 9), voir photos 18 et 19, notez que vous
devrez monter le linceul de feu puis utiliser un peu d’adhésif pour fixer la
position. Appliquer une longueur de manchon thermo rétractable (article 10) sur