PKS0115
R&G
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
Page | 4
ARTICLE 2 = BASE PLATE (MP0216) (x1)
ARTICLE 3 = M5 x 8mm BOULONS (x4)
OUTILS REQUIS
•
Clé Allen 3mm.
•
Verrouillage du filetage (Bleu).
NOTICE DE MONTAGE
•
Prenez l’attache puis placez-là autour avec les trous orientés vers le haut et positionnez-la autour de la béquille
latérale.
•
Monter la base plate au-dessous de la base de béquille latérale.
•
Appliquer un peu de colle (un filet) de verrouillage du filetage (Bleu) sur l’extrémité du filetage de chaque vis.
•
Insérer les 4 boulons M5 pour emboiter les 2 plaques ensemble puis fixer sur le pied de béquille latérale.
•
Serrer tous les boulons de façon identique puis vérifier que le coussin de béquille latérale ne touche pas la chaine
en position relevée.
•
Si l’installation s’effectue sur une béquille usée, la bande de rembourrage doit être placée sur la base plate pour
assurer une installation plus précise.
ISSUE 11/07/2018 (HB)
Notice disponible au téléchargement sur
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not
diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or
warranty (other than as to title) has been given or will apply to the Products other than those in R&G’s order or confirmation and the Buyer confirms it
has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other
services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is
responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G
shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or used or
maintained otherwise than in accordance with R&G’s or manufacturer’s instructions and good engineering practice or if the defect arises from accident
or neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for
indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service
concerned. These terms do not affect the Buyer’s statutory rights.
R&G RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of
R&G. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The
customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your
statutory rights and does not refer to faulty goods.
