Page
5
of
17
RAD0262
R&G Racing
Unit 1, Shelley’s
Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
FITTING INSTRUCTIONS:
FAIRING PANEL REMOVAL:
•
Remove the bolts shown in
Image 1
using a 4mm
Allen key.
•
Using the same size Allen key remove the hidden bolt inside of the fairing panel
(shown in
Images 2 & 3
).
•
You may now gently remove the upper panel from the pin on the tank (
Image 4
) &
store it safely until you are ready to re-install.
•
Removing the lower panel requires the removal of the two bolts seen in
Image 5
which are revealed after the removal of the upper panel.
•
Once the two upper mounting bolts have been removed, the lower mounting bolt
(shown in
Image 6
) will be the only bolt holding the lower panel in position, so be
sure to support the panel while removing the final bolt.
•
Repeat these steps for the remaining fairing panels on the other side of the
motorcycle.
OIL COOLER SHROUD REMOVAL:
•
Once both lower bolts pictured in
Image 6
have been removed, the oil cooler shroud
will only be held in position by a rubber mounted pin, so be sure to either
immediately remove the shroud or support the shroud until you are ready to do so.
•
Once the LHS & RHS fairing panels have been removed the oil cooler shroud will be
held in position by the pin shown in
Image 7
at the bottom of the oil cooler.
•
Lower the shroud until it can be removed from the pin, then store away safely until
ready to re-install.
RADIATOR GUARD INSTALLATION:
•
Now all fairing panels have been removed, the radiator mounting points will be
accessible. (
Image 8
)
•
Cut & apply the supplied adhesive foam in various positions around the back side of
the radiator guard, this will protect the radiator from any rubbing & prevent any
rattling that can sometimes occur with vibration.
•
Insert the top two cable ties into position on the radiator guard (shown in
Image 9
),
then offer up the guard to the radiator.
•
Wrap the cable ties around the radiator mounting tabs and loosely zip the cable ties
up to allow fitment of the lower cable ties & fine tuning of positioning once all cable
ties are attached. (
Image 10
)
•
Once you are happy with the position of the radiator guard, slowly tighten each cable
tie one at a time until the guard is firmly secured into position.
•
Cut excess cable tie length using scissors or clippers then re-install all panels in
reverse of the order shown above.
ISSUE 1: 07/04/2021 (TB)
