Page
2
of
9
SCN0011
R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
www.rg-racing.com
Email:
info@rg-racing.com
- 2 -
PICTURE 1
PICTURE 2
FITTING INSTRUCTIONS
Remove the 4 original screws fastening the screen, and carefully remove the
original screen.
Remove the rubber grommets or fasteners from the original screen and place them
in the same orientation into your R&G screen as seen in pictures 1 and 2.
Carefully place your R&G screen into the fairing in the same fashion as the
original screen, making sure not to mark or damage either the screen or
surrounding bodywork.
At this stage check to make sure all mounting holes line up correctly and no parts
are deformed.
Starting with the front two fasteners to hold the screen in place, insert the two
remaining screws working from the front working rearward. Leave them loose in
case you may need to adjust the position of the windscreen slightly to align all the
holes and fasteners.
Once the windscreen is loosely mounted, begin tightening the fasteners from the
front. DO NOT OVER-TIGHTEN as this could cause the screen to crack or
damage bodywork.
Check all fixings are secure and the screen is fitted correctly.