Page
2
of
12
TG0018
R&G
Unit
1
, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)
1
420 89007 Fax: +44 (0)
1
420 87301 www.rg-racing.com Email: info@rg-racing.com
LEGEND
ITEM No.
DESCRIPTION
QTY
ITEM 1
MTG0018 CHAIN & SPROCKET GUARD
1
ITEM 2
M0614 MOUNT BLOCK
1
ITEM 3
M6x25MM CAP HEAD BOLT
2
ITEM 4
M6x15MM COUNTERSUNK BOLTS
2
ITEM 5
S1283 M6 COMPRESSION SLEEVE
1
ITEM 6
S1284 M8 COMPRESSION SLEEVE
1
ITEM 7
M10x19MM O/D WASHER
1
ITEM 8
M10 ANTI-ROTATION WASHER
1
ITEM 9
M6x25mm BUTTON HEAD BOLT
1
ITEM 10
M8x25mm BUTTON HEAD BOLT
1
ITEM 11
M10x25mm BUTTON HEAD BOLT
1
FITTING INSTRUCTIONS
THE INSTRUCTIONS BELOW DETAIL TWO SEPARATE FITTING OPTIONS. CHOOSE
WHICH IS MOST SUITABLE FOR YOUR BIKE.
•
For all fitting options, when positioning the Chain and Sprocket guard, ensure that:
o
The lower chain and sprocket area are covered.
o
The flat rear section of the Chain & Sprocket guard should cover the lower section of the
sprocket.
o
The Chain and sprocket guard should be placed in parallel with the chain where it cannot
come into contact with any moving components of the motorcycle. Consider any vertical
or lateral movement of the chain and wheel assembly when placing the Chain & Sprocket
guard.
o
Where bikes are fitted with a lower boss for aftermarket Cotton Reels for use with a
paddock stand. Where applicable, the mount block (
item 2
) can be placed over this
giving greater flexibility when fitting, in this instance, fit the Cotton Reel to help position
the block as shown in the example on page 3.
o
See example of the intended coverage below:
TOOLS REQUIRED
•
5MM DRILL BIT + DRILL
•
M6 x 1.00 TAP + TAP WRENCH
•
MARKER
•
PUNCH
•
4mm & 5mm HEX KEYS
GENERAL TORQUE SETTINGS
M4 BOLT = 8Nm
M5 BOLT = 12Nm
M6 BOLT = 15Nm
M8 BOLT = 20Nm
M10 BOLT = 40Nm
M12 BOLT = 40Nm
