LM05 SERIES II I&M MANUAL/EN/11.30.2010
61/89
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
8
PREVENTATIVE MAINTENANCE
8.1 Maintenance and Inspection Table
Table 11. Maintenance and Inspection Schedule
INSPECTION CHECK
INTERVAL
QUALIFIED PERSON
BRAKE OPERATION FOR HOLDING AND RELEASING
DAILY
OPERATOR
LOAD CHAIN FOR DAMAGE
DAILY
OPERATOR
SUSPENSION SUPPORT OF P/ B ASSEMBLY
DAILY
OPERATOR
CLEANLINESS & LUBRICATION OF LOAD CHAIN
MONTHLY
OPERATOR
UPPER / LOWER LIMIT SWITCHES
DAILY
OPERATOR
CHECK LOAD CHAIN FOR WEAR – MEASURE AND RECORD
EVERY 3 MONTHS
QUALIFIED INSPECTOR
CHECK HOOKS FOR WEAR MEASURE AND RECORD
EVERY 3 MONTHS
QUALIFIED INSPECTOR
CHECK LOAD BLOCK HARDWARE TO VERIFY TIGHTNESS
EVERY 3 MONTHS
OPERATOR
CHECK TOP HOOK / COUPLING HARDWARE FOR TIGHTNESS
EVERY 3 MONTHS
OPERATOR
CHECK SLIP CLUTCH & HOIST BRAKE ADJUSTMENT
EVERY 3 -6 MONTHS
QUALIFIED MECHANIC
CHECK LUBRICATION OF OPEN WHEEL GEARING
EVERY 3 -6 MONTHS
QUALIFIED MECHANIC
CHECK WIRE TERMINALS TIGHTNESS
SEMI-ANNUALLY
QUALIFIED MECHANIC
LUBRICATE 2-FALL LOAD BLOCK SPROCKET
ANNUALLY
OPERATOR
CHECK ALL HARDWARE FOR TIGHTNESS AND CORROSION
ANNUALLY
QUALIFIED MECHANIC
CLEAN MOTOR COOLING FINS
ANNUALLY
QUALIFIED MECHANIC
LUBRICATE ALL GEARING
ANNUALLY
QUALIFIED MECHANIC
INSPECT LOAD BLOCK THRUST BEARING
ANNUALLY
QUALIFIED MECHANIC
m
CAUTION: INSPECTION AND MAINTENANCE INTERVALS SHOULD BE ADJUSTED BASED
UPON OWNER / USER KNOWLEDGE OF APPLICATION, ENVIRONMENT, AND FREQUENCY
OF USE TO PREVENT DAMAGE TO PEOPLE, EQUIPMENT, AND FACILITIES.
