Configuring the R&S TSMA6B
R&S
®
TSMA6B
49
User Manual 4901.4026.02 ─ 01
For Bluetooth
®
preparation, the device must be in the "PC Mode". Check it via the web
GUI ("Home" > "Overview").
To change the operation mode, navigate to "Configuration" > "System" > "Mode" and
select an operation mode.
1. In the web-GUI, verify the Bluetooth
®
settings on R&S TSMA6B.
Figure 6-7: Bluetooth settings
2. Navigate to "Configuration" > "Connectivity" > "Bluetooth" and verify the settings:
● STATUS = On
● Visibility = Visible
If necessary, change the settings via the buttons on the right.
3. On the remote device, activate Bluetooth and enable visibility.
Note:
For devices with Android versions
≥
5.0, there may be problems with visibil-
ity of the device.
Refer to
device not detected by R&S TSMA6B"
4. In the R&S TSMA6B web GUI, click "Refresh Device List".
The status text shows the following: "Refreshing device list in progress".
Wait until "No Error" is shown.
5. Click the arrow next to the "Refresh Device List" button and open the Bluetooth
adapter list box
6. Select the device to be paired and click "Connect".
7. On the remote device, confirm the Bluetooth pairing code.
Pairing Bluetooth
®
devices
