Configuring the R&S TSMA6B
R&S
®
TSMA6B
46
User Manual 4901.4026.02 ─ 01
2. Configure the following settings. For the initial settings after installation, see
ter 8.4.3.3, "Initial software start / measurement mode selection"
● Autostart
● Workspace File
In the drop-down menu, select a ROMES workspace file (see
● Recording
Activating this checkbox, the SmartONE measurement data are written to the
TSMA6B hard disk.
● IP Controlled
Activating this checkbox, you can control the SmartONE measurement via IP
from an external host PC.
3. Click "Submit" to save your selection.
For more details about the R&S
SmartONE configuration and usage, refer to the user
documentation for R&S
SmartONE.
6.3.1.6
Scanner mode
You can use the R&S TSMA6B as scanner only. In this case, the R&S TSMA6B
behaves like a R&S TSME6. The internal CPU is not powered, only the scanner is
switched on.
Scanner mode
To use the R&S TSMA6B in scanner mode, proceed as follows.
1. Use a pointed object to push the CPU switch (1) to position 0.
Selecting measurement mode
