Interfaces and Connectors
R&S
®
DVMS1
24
Getting Started 2113.7619.02 ─ 12
An LED indicates the TS OUT status:
●
LED off: Output is not used.
●
LED blue: Output is used as loop output.
3.2.12
TS/IP Interface Module (R&S
DVMS-B40)
The TS/IP module (R&S
DVMS
‑
B40) is an option module.
Figure 3-8: TS/IP interface module
TS IN/OUT 1 and TS IN/OUT 2
Each of these two BNC sockets is used either as input or output for MPEG2 transport
streams. If used as an input, feed in an MPEG2 transport stream signal conforming to
the DVB
‑
ASI (EN 50083
‑
9 (2002)) or SMPTE (SMPTE310M) interface standards. If
used as an output, this socket provides an MPEG2 transport stream signal conforming
to the DVB
‑
ASI (EN 50083
‑
9 (2002)) interface standard. The output can be used as a
loop output for any transport stream input signal available.
To select the input or output, in the toolbar, click "Instrument Configuration" and then
select "Signal Interface". See the user manual or help system.
The status of the connectors is indicated by LEDs. Before showing a new status, each
LED holds the status for at least one second, if the status is not "off" or "flashing".
●
LED off: Connector is not used.
●
LED blue: Connector is used as a loop output for any MPEG2 transport stream
input signal.
●
LED green: Connector is used as an input for monitoring. Synchronization state is
valid for the transport stream signal.
●
LED yellow: Connector is used as an input for monitoring but synchronization can-
not be achieved.
To help locating a connector socket, you can let its status LED flash ("Instrument Con-
figuration" dialog, "Signal Interfaces" tab, see the user manual or help system).
1000 BASE-T
This 1000
Base
‑
T gigabit interface socket is used either as:
●
Input for IP and TS monitoring (IP in flow)
●
IP loop output (IP out flow) for encapsulated MPEG2 transport streams conforming
to the Pro-MPEG code of practice #3 (release 2)
Rear Panel
