Sample Application
R&S
®
DVMS1
35
Getting Started 2113.7619.02 ─ 12
Figure 6-2: Monitoring view
7. Compare this value to the gross value from before (see
the Gross Bit Rate of the Connected TS"
Since only the packet payload of all TS packets is examined for net bit rate calcula-
tion, the net value should be lower by a factor of approximately 184/188.
6.5.3
Activating the Monitoring Error for TS Bit Rate Monitoring
Now you activate monitoring errors by changing the monitoring limit of the parameter
TS bit rate.
1. In the toolbar, select "Monitoring Configuration".
2. Select the "Extended Checks I" tab (see
In the second line, in the "Upper Bit Rate" field, set the limit to a value of approx.
1
Mbit/s below the current TS bit rate as checked in
Net Bit Rate of the Connected TS"
3. Click "OK" to close the configuration dialog.
4. In the toolbar, click "View Selector".
5. In the "View Selector" dialog, click the icon for the statistics
&
log measurement.
6. Click "Control" and select "Clear Statistics & Log".
7. Check the monitoring log.
Performing the Measurement
