Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1197
User Manual 1178.8520.02 ─ 01
<li>
<t>
irrelevant
Parameters:
<TraceNumber>
1 to 6
*RST:
1
Example:
CALC:LIM2:TRAC 3
Assigns limit line 2 to trace 3.
DISPlay[:WINDow<n>]:STATe
<State>
This command changes the display state of the selected measurement window.
Note that this command is maintained for compatibility reasons only. Use the
LAYout
commands for new remote control programs
(See
Chapter 14.6.2, "Working with Windows in the Display"
Suffix:
<n>
.
Parameters:
<State>
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
DISPlay[:WINDow<n>]:TYPE
<WindowType>
This command selects the results displayed in a measurement window.
Note that this command is maintained for compatibility reasons only. Use the
LAYout
commands for new remote control programs (see
Chapter 14.6.2, "Working with Win-
The parameter values are the same as for
Suffix:
<n>
.
Parameters:
<WindowType>
DIAGram | RSUMmary | MTABle | PEAKlist | SGRam
HCOPy:ITEM:ALL
This command is maintained for compatibility reasons only. It has no effect.
SOURce<si>:EXTernal<gen>:FREQuency:SWEep[:STATe]
<State>
Note that this command is maintained for compatibility reasons only. It is not required
in new remote control programs.
Deprecated Commands