Measurements and Results
R&S
®
FSVA3000/ R&S
®
FSV3000
159
User Manual 1178.8520.02 ─ 01
The remote commands required to perform these tasks are described in
ter 14.5.3, "Measuring the Channel Power and ACLR"
General CP/ACLR Measurement Settings
............................................................159
7.3.4.1
General CP/ACLR Measurement Settings
General measurement settings are defined in the "ACLR Setup" dialog, in the "General
Settings" tab.
.................................................................................. 159
............................................................................................ 160
.....................................................................................160
Absolute and Relative Values (ACLR Mode)
............................................................. 162
Channel power level and density ( Power Unit )
......................................................... 162
Setting a fixed reference for Channel Power measurements ( Set CP Reference )
Optimized Settings ( Adjust Settings )
.........................................................................163
Standard
The main measurement settings can be stored as a standard file. When such a stan-
dard is loaded, the required channel and general measurement settings are automati-
cally set on the R&S
FSV/A. However, the settings can be changed. Predefined stand-
ards are available for standard measurements, but standard files with user-defined
configurations can also be created.
Predefined Standards ← Standard
Predefined standards contain the main measurement settings for standard measure-
ments. When such a standard is loaded, the required channel settings are automati-
cally set on the R&S
FSV/A. However, the settings can be changed.
The predefined standards contain the following settings:
●
Channel bandwidths
●
Channel spacings
●
Detector
●
Trace Average setting
●
Resolution Bandwidth (RBW)
●
Weighting Filter
Predefined standards can be selected via the "CP / ACLR Standard" softkey in the "Ch
Power" menu or in the "General Settings" tab of the "CP / ACLR Config" dialog box.
For details on the available standards, see
Chapter 7.3.9, "Reference: Predefined CP/
Channel Power and Adjacent-Channel Power (ACLR) Measurement