Measurements and Results
R&S
®
FSVA3000/ R&S
®
FSV3000
185
User Manual 1178.8520.02 ─ 01
11. If power limits are defined and activated, activate global limit checking for the mea-
surement on the "MSR General Settings" tab.
12. Optionally, store the settings for the MSR ACLR measurement as a user-defined
"To store a user-defined configuration"
erwise the configuration is lost when you select a different measurement standard.
7.3.6.4
How to Manage User-Defined Configurations
You can define measurement configurations independently of a predefined standard
and save the current ACLR configuration as a "user standard" in an XML file. You can
then load the file and thus the settings again later.
User-defined standards are not supported for "Fast ACLR" and multicarrier ACLR mea-
surements.
Compatibility to R&S FSP
User standards created on an analyzer of the R&S FSP family are compatible to the
R&S
FSV/A. User standards created on an R&S
FSV/A, however, are not necessarily
compatible to the analyzers of the R&S FSP family and may not work there.
To store a user-defined configuration
1. In the "Ch Power" menu, select the "CP / ACLR Config" softkey to display the
"ACLR Setup" dialog box.
2. Configure the measurement as required (see also
Chapter 7.3.6.2, "How to Set Up
3. In the "General Settings" tab, select the "Manage User Standards" button to display
the "Manage" dialog box.
4. Define a filename and storage location for the user standard.
By default, the XML file is stored in
C:\Program Files\Rohde-Schwarz\FSV3000\<version>\acp_std\
.
However, you can define any other storage location.
5. Select "Save" .
To load a user-defined configuration
1. In the "General Settings" tab of the "ACLR Setup" dialog box, select the "Manage
User Standards" button to display the "Manage" dialog box.
2. Select the user standard file.
3. Select "Load" .
The stored settings are automatically set on the R&S
FSV/A and the measurement
is restarted with the new parameters.
Channel Power and Adjacent-Channel Power (ACLR) Measurement
