Common Analysis and Display Functions
R&S
®
FSVA3000/ R&S
®
FSV3000
482
User Manual 1178.8520.02 ─ 01
How to edit existing limit lines
Existing limit line configurations can be edited.
1. In the "Line Config" dialog box, select the limit line.
2. Select the "Edit" button.
3. Edit the line configuration as described in
"How to configure a new limit line"
4. Save the new configuration by selecting the "Save" button.
If the limit line is active, the edited limit line is displayed in the diagram.
How to copy an existing limit line
1. In the dialog box, select the limit line.
2. Select the "Line Config" "Copy To" button.
3. Define a new name to create a new limit with the same configuration as the source
line.
4. Edit the line configuration as described in
"How to configure a new limit line"
5. Save the new configuration by selecting the "Save" button.
The new limit line is displayed in the overview and can be activated.
How to delete an existing limit line
1. In the "Line Config" dialog box, select the limit line.
2. Select the "Delete" button.
3. Confirm the message.
The limit line and the results of the limit check are deleted.
How to configure a new limit line
1. In the "Line Config" dialog box, select the "New" button.
The "Edit Limit Line" dialog box is displayed. The current line configuration is dis-
played in the preview area of the dialog box. The preview is updated after each
change to the configuration.
2. Define a "Name" and, optionally, a "Comment" for the new limit line.
3. Define the x-axis configuration:
● Time domain or frequency domain
● Absolute or relative limits
● Linear or logarithmic scaling
4. Define the y-axis configuration:
● Level unit
Display and Limit Lines
