Network and Remote Operation
R&S
®
FSVA3000/ R&S
®
FSV3000
696
User Manual 1178.8520.02 ─ 01
FSW = VisaResourceManager.open_resource("TCPIP::10.124.0.195::INSTR")
# Display update ON
FSW.write("SYST:DISP:UPD ON")
FSW.write("*RST")
FSW.write("INIT:CONT OFF")
FSW.write("SENS:FREQ:CENT 850000000")
FSW.write("SENS:FREQ:SPAN 4000000")
FSW.write("DISP:WIND:SUBW:TRAC:Y:SCAL:RLEV 10")
FSW.write("CALC:MARK:FUNC:POW:SEL ACP")
FSW.write("CALC:MARK:FUNC:POW:PRES S2CD")
FSW.write("SENS:ADJ:LEV;*WAI")
FSW.write("SENS:POW:HSP ON")
FSW.write("TRAC1:DATA? TRACE1")
FSW.query("CALC1:MARK:Y?")
FSW.write("CALC1:MARK:FUNC:POW:RES? CPOW")
# Back to local mode
FSW.write("@LOC")
13.5
Network and Remote Control Settings
Access
: [SETUP] > "N Remote"
Network settings in secure user mode
Be sure to store all network settings before
ter 5.1.7, "Protecting Data Using the Secure User Mode"
If the currently stored network settings are not suitable, you must correct them each
time you switch on the R&S
FSV/A in secure user mode, as the settings are not stored
permanently in this case.
The remote commands required to define these settings are described in
ter 14.10.7, "Configuring the Network and Remote Control"
Step-by-step instructions are provided in
Chapter 13.6, "How to Set Up a Network and
..................................................................................... 697
............................................................................................702
Returning to Manual Mode ("Local")
..................................................................... 709
Network and Remote Control Settings