Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
882
User Manual 1178.8520.02 ─ 01
LAYout:WINDow<n>:REMove
This command removes the window specified by the suffix <n> from the display in the
active channel.
The result of this command is identical to the
command.
Suffix:
<n>
.
Example:
LAY:WIND2:REM
Removes the result display in window 2.
Usage:
Event
LAYout:WINDow<n>:REPLace
<WindowType>
This command changes the window type of an existing window (specified by the suffix
<n>) in the active channel.
The effect of this command is identical to the
mand.
To add a new window, use the
command.
Suffix:
<n>
.
Setting parameters:
<WindowType>
Type of measurement window you want to replace another one
with.
See
on page 876 for a list of availa-
ble window types.
Example:
LAY:WIND2:REPL MTAB
Replaces the result display in window 2 with a marker table.
Usage:
Setting only
14.6.3
Examples: Configuring the Result Display
The following example demonstrates how to configure result displays in a remote envi-
ronment.
14.6.3.1
Example 1: Adding and Arranging Windows
Starting from the default initial display in the Spectrum application (Frequency Sweep),
we will configure the following result displays:
1 Frequency Sweep
3 Marker Table
2 Spectrogram
4 Marker Peak List
Configuring the Result Display
