Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
889
User Manual 1178.8520.02 ─ 01
Parameters:
<Span>
The minimum span for measurements in the frequency domain
is 10
Hz.
Range:
0 Hz to fmax
*RST:
Full span
Default unit: Hz
Manual operation:
See
See
See
See
[SENSe:]FREQuency:SPAN:FULL
This command restores the full span.
Manual operation:
See
[SENSe:]FREQuency:STARt
<Frequency>
This command defines a start frequency for measurements in the frequency domain.
Parameters:
<Frequency>
0 to (fmax - min span)
*RST:
0
Default unit: HZ
Example:
FREQ:STAR 20MHz
Manual operation:
See
See
[SENSe:]FREQuency:STOP
<Frequency>
This command defines a stop frequency for measurements in the frequency domain.
Parameters:
<Frequency>
min span to fmax
*RST:
fmax
Default unit: HZ
Example:
FREQ:STOP 2000 MHz
Manual operation:
See
See
14.7.1.2
Configuring Signal Tracking
When signal tracking is activated, the maximum signal is determined after each fre-
quency sweep and the center frequency is set to the frequency of this signal. Thus with
drifting signals the center frequency follows the signal.
Setting Basic Measurement Parameters