Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
229
User Manual 1173.9240.02 ─ 23
Parameters:
<Edge>
POSitive
The measurement starts in case the trigger signal shows a posi-
tive edge.
NEGative
The measurement starts in case the trigger signal shows a neg-
ative edge.
*RST:
POSitive
Example:
PMET2:TRIG:SLOP NEG
Manual operation:
See
[SENSe:]PMETer<p>:TRIGger[:STATe]
<State>
This command turns the external power trigger on and off.
Suffix:
<p>
.
1...4
Power sensor index
Parameters:
<State>
ON | OFF | 1 | 0
*RST:
0
Example:
PMET2:TRIG ON
Switches the external power trigger on
Manual operation:
See
"Using the power sensor as an external trigger"
11.4.2.8
External Generator Control
External generator control commands are available if the R&S
FSW External Genera-
tor Control option (R&S
FSW-B10) is installed.
For each measurement channel one external generator can be configured. To switch
between different configurations define multiple measurement channels.
For more information on external generator control see
..................................................................................229
..........................................................................................232
.................................................................................................235
Programming Example for External Generator Control
........................................ 237
Measurement Configuration
The following commands are required to activate external generator control and to con-
figure a calibration measurement with an external tracking generator.
.......................................................................................230
SOURce:EXTernal:FREQuency:COUPling[:STATe]
.......................................................... 230
SOURce:EXTernal:FREQuency[:FACTor]:DENominator
.................................................... 230
Configuring the Measurement