Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
289
User Manual 1173.9240.02 ─ 23
Parameters:
<State>
ON | 1
The automatic reset is off.
OFF | 0
The automatic reset is on.
*RST:
0
Example:
DISP:WIND:TRAC3:MODE:HCON ON
Switches off the reset function.
Manual operation:
See
DISPlay[:WINDow<n>]:TRACe<t>:SELect
This command selects the trace specified by the index <t> in the window specified by
the index <n>. Only traces that are active in the specified result display can be
selected. The selected trace is used to determine the "Result Summary" for the corre-
sponding result display (see
The query returns the number of the currently selected trace in the window specified by
the index <n> (trace index is ignored). Traces can only be queried for graphical result
displays (not Result Summary, Marker Table or Peak Marker List).
Return values:
<TraceNo>
Number of the currently selected trace.
Example:
DISP:TRAC3:SEL
DISPlay[:WINDow<n>]:TRACe<t>[:STATe]
<State>
This command turns a trace on and off.
The measurement continues in the background.
Suffix:
<n>
.
<t>
Parameters:
<State>
ON | OFF | 1 | 0
*RST:
1 for TRACe1, 0 for TRACe 2 to 6
Example:
DISP:TRAC3 ON
Manual operation:
See
"Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6"
on page 134
See
"Trace 1/Trace 2/Trace 3/Trace 4 (Softkeys)"
[SENSe:]ADEMod<n>:AM[:ABSolute][:TDOMain][:TYPE]
[SENSe:]ADEMod<n>:AM:RELative[:TDOMain][:TYPE]
[SENSe:]ADEMod<n>:AM:RELative:AFSPectrum[:TYPE]
[SENSe:]ADEMod<n>:FM[:TDOMain][:TYPE]
Configuring the Measurement
