Configuration
R&S
®
FSW-K7
50
User Manual 1173.9240.02 ─ 23
2. Trigger
Chapter 5.4, "Trigger Configuration"
3. Data Acquisition
Chapter 5.5, "Data Acquisition"
4. Demod/Display
Chapter 5.6, "Demodulation Display"
5. Demodulation Settings
6. Analysis
7. (Optionally:) Outputs
Chapter 5.8.1, "Output Settings"
To configure settings
► Select any button in the "Overview" to open the corresponding dialog box.
Select a setting in the channel bar (at the top of the measurement channel tab) to
change a specific setting.
Preset Channel
Select the Channel button in the lower lefthand corner of the "Overview" to restore all
measurement settings
in the current channel
to their default values.
Do not confuse the Channel button with the PRESET
key
, which restores the entire
instrument to its default values and thus closes
all measurement channels
on the
R&S
FSW (except for the default Spectrum application channel)!
Remote command:
Setup Standard
Opens a file selection dialog box to select a predefined setup file. See
Specifics for
The measurement channel may contain several windows for different results. Thus, the
settings indicated in the "Overview" and configured in the dialog boxes vary depending
on the selected window.
Select an active window from the "Specifics for" selection list that is displayed in the
"Overview" and in all window-specific configuration dialog boxes.
The "Overview" and dialog boxes are updated to indicate the settings for the selected
window.
Configuration Overview
