Configuration
R&S
®
FSW-K7
88
User Manual 1173.9240.02 ─ 23
5.3.3.1
Amplitude Settings for RF Input
Amplitude settings can be configured via the AMPT key or in the "Amplitude" dialog
box.
To display the "Amplitude" dialog box, do one of the following:
●
Select "Amplitude" from the "Overview".
●
Select the AMPT key and then the "Amplitude Config" softkey.
The remote commands required to define these settings are described in
ter 11.4.5, "Configuring the Vertical Axis (Amplitude, Scaling)"
............................................................................ 89
Setting the Reference Level Automatically (Auto Level)
.................................89
.................................................................................................90
................................................................................90
......................................................................................... 90
.................................................................................................91
Reference Level
Defines the expected maximum input signal level. Signal levels above this value may
not be measured correctly, which is indicated by the "IF OVLD" status display ("OVLD"
for analog baseband or digital baseband input).
The reference level can also be used to scale power diagrams; the reference level is
then used as the maximum on the y-axis.
Input and Frontend Settings
