Remote Control Commands
R&S
®
NGL200/NGM200
114
User Manual 1178.8736.02 ─ 05
OUTPut:DELay[:STATe]
<state>
OUTPut:DELay[:STATe]?
Sets or queries the output delay state for the selected channel.
Parameters:
<state>
OFF | ON | 0 | 1
OFF | 0
Deactivates output delay for the selected channel.
ON | 1
Activates output delay for the selected channel.
Example:
OUTPut:DELay 1
OUTPut:DELay?
-> 1
Returns output delay state as on.
OUTPut:FTResponse
<state>
OUTPut:FTResponse?
Sets or queries the fast transient response state.
Parameters:
<state>
OFF | ON | 0 | 1
OFF | 0
Deactivates fast transient response.
ON | 1
Activates fast transient response.
Example:
OUTPut:FTResponse 1
OUTPut:FTResponse?
-> 1
Returns fast transient response state as on.
OUTPut:IMPedance
<resistance>
OUTPut:IMPedance?
Sets or queries source impedance for the signal specified in ohms.
Parameters:
<arg0>
numeric | MIN | MAX | DEFault
numeric
Numeric value of the impedance ohm.
MIN
Minimum value of the impedance at -0.05 ohms.
MAX
Maximum value of the impedance at 100 ohms.
DEF
Default value of the impedance at 0 ohms.
*RST:
0
Default unit: ohm
Configuration Commands
