Remote Control Commands
R&S
®
NGL200/NGM200
116
User Manual 1178.8736.02 ─ 05
OUTPut:SELect
<state>
OUTPut:SELect?
Sets or queries the output state of selected channel.
Parameters:
<state>
OFF | ON | 0 | 1
OFF | 0
Deactivates the selected channel.
ON | 1
Activates the selected channel.
*RST:
OFF | 0
Example:
See
Example "Activating the channels"
OUTPut:TRIGgered
<arg0>
OUTPut:TRIGgered[:STATe]
<arg0>
Enables or disables the triggered event for output.
Setting parameters:
<arg0>
1
Trigger is enabled.
0
Trigger is disabled.
Example:
OUTP:TRIG 1
When a trigger event occurs, respective channel output is trig-
gered.
See
OUTPut:TRIGgered:BEHavior
<arg0>
Sets or queries output behavior when a trigger event occurs.
Setting parameters:
<arg0>
ON | OFF | GATed
ON
Output is set on when a trigger event occurs.
OFF
Output is set off when a trigger event occurs.
ON
Output is set gated when a trigger event occurs.
Example:
OUTP:TRIG:STAT 1
OUTP:TRIG:BEH ON
Configuration Commands
