Remote Control Commands
R&S
®
NGL200/NGM200
143
User Manual 1178.8736.02 ─ 05
Parameters:
<arg0>
Sets the value for battery state of charge (SoC).
<arg1>
Sets the value for battery open-circuit voltage (Voc).
<arg2>
Sets the value for battery internal resistance (ESR).
Example:
BATT:MOD:DATA 0,0.0,2.0,100,5.0,2.0
Sets the battery model data.
BATTery:MODel:FNAMe
<Filename>[,<Partition>]
BATTery:MODel:FNAMe?
<Filename>[,<Partition>]
Sets or queries a filename for the battery model.
Parameters for setting and query:
<Filename>
Filename for the battery model.
<Partition>
INT | EXT | DEF
Selects partition for file storage.
INT
Internal memory used for file storage
EXT
USB stick used for file storage
DEF
If USB stick is used, default storage partition is set to EXT.
Example:
BATT:MOD:FNAM "NEwBattery.csv",INT
Sets the battery model filename to "NewBattery.csv" (internal
memory).
BATTery:MODel:ISOC
<State_of_charge>
Sets or queries the initial state of charge (SoC) of the battery model.
Parameters:
<State_of_charge>
Initial state of charge (SoC) for the battery model.
Example:
INST:NSEL 1
BATT:MOD:ISOC 50
Initial state of charge is set to 50 % for channel 1.
BATTery:MODel:LOAD
<filename>
Loads a battery model for editing.
Example:
BATT:MOD:LOAD
Loads the current battery model to a file.
Usage:
Event
Advanced Operating Commands
