Remote Control Commands
R&S
®
NGL200
118
User Manual 1178.8736.02 ─ 02.01
Usage:
Setting only
ARBitrary:TRIGgered:MODE
<mode>
ARBitrary:TRIGgered:MODE?
Sets/Queries the arbitrary trigger mode of the previous selected channel.
Parameters:
<mode>
SINGle | RUN
SINGle
A trigger event starts only one arbitrary sequence.
RUN
A trigger event starts the whole arbitrary sequence (with all repi-
titions).
ARBitrary:TRIGgered[:STATe]
<state>
ARBitrary:TRIGgered[:STATe]?
Activates/Deactivates or Queries the trigger input at the rear connector (terminal block)
for arbitrary functionality..
Parameters:
<state>
0 | 1
0
OFF - Trigger input is deactivated.
1
ON - Trigger input is activated.
Example:
INST OUT1
ARB:TRIG ON
ARB:TRIG? -> 1
Trigger input on the rear connector is activated for Ch1 arbitrary
waveform
7.8
Advanced Operating Commands
The
VOLTage:RAMP
and
Sequencing
subsystem contains the commands for config-
uring the ramp function and sequencing function for the output channels.
7.8.1
Ramp
..................................................................................119
[SOURce:]VOLTage:RAMP:DURation
...............................................................................119
Advanced Operating Commands
