Instrument Functions
R&S
®
NGL200
70
User Manual 1178.8736.02 ─ 02.01
● "ON": Enables DHCP for automatic network parameter distribution and shows
the values of the IP Address. By default, the instrument is configured to use
dynamic configuration and obtain all address information automatically.
● "OFF": To be used if the network does not support dynamic host configuration
protocol (DHCP). The addresses must be set manually.
4. Set the required DHCP mode.
If DHCP mode is set "OFF", the following "Ethernet Settings" are not required
5. Configure the "IP Address", "Subnet Mask" and "Gateway".
The R&S
NGL200 displays the IP dialog for configuration.
Figure 6-31: IP dialog
6. Set the required IP for "IP Address", "Subnet Mask" and "Gateway"
7. Select "Set" to confirm the value.
6.10.1.2
Wireless LAN Connection
R&S NGL-K102 (3652.6362.02) option is required to connect the R&S
NGL200 to a
network via wireless LAN connection.
An alterative to connection in local area network is wireless LAN connection. With the
presence of an authenticated Wi-Fi signal, the R&S
NGL200 automatically connects to
a network and navigation can be made via the web browser according to the WLAN
IEEE 802.11 b/g/n standards.
1. Select "Wireless LAN" to set LAN connection.
The R&S
NGL200 displays the "Wireless LAN Settings" dialog.
Interfaces
