Remote Control Commands
R&S
®
NGL200
101
User Manual 1178.8736.02 ─ 02.01
ON | 1
Activates output delay for the selected channel.
Example:
OUTPut:DELay 1
OUTPut:DELay? -> 1
Return output delay state as on.
OUTPut:FTResponse
<state>
OUTPut:FTResponse?
Activates/Deactivates or queries the fast transient response.
Parameters:
<state>
OFF | ON | 0 | 1
OFF | 0
Deactivates fast transient response.
ON | 1
Activates fast transient response.
Example:
OUTPut:FTResponse 1
OUTPut:FTResponse? -> 1
Return fast transient response state as on.
OUTPut:IMPedance
<resistance>
OUTPut:IMPedance?
Outputs/Queries source impedance for the signal specified in ohms.
Parameters:
<arg0>
numeric | MIN | MAX | DEFault
numeric
Numeric value of the impedance ohm.
MIN
Minimum value of the impedance at -0.05 ohms.
MAX
Maximum value of the impedance at 100 ohms.
DEF
Default value of the impedance at 0 ohms.
*RST:
0
Default unit: ohm
Example:
OUTPut:IMPedance 1
OUTPut:IMPedance? -> 1
Return output impedance of 1 ohm.
Configuration Commands