Remote Control Commands
R&S
®
NGL200
94
User Manual 1178.8736.02 ─ 02.01
[SOURce:]CURRent[:LEVel][:IMMediate]:STEP[:INCRement]
<stepsize>
[SOURce:]CURRent[:LEVel][:IMMediate]:STEP[:INCRement]?
[<stepsize>]
Sets/Queries the incremental step size for the
Setting parameters:
<stepsize>
numeric | DEFault
numeric
Step value in A.
DEFault
Default value of stepsize.
Range:
0.0001 to 2.000
Increment: 0.0001
*RST:
0.010
Default unit: A
Query parameters:
<stepsize>
DEFault
Queries the default voltage step size.
Example:
INST OUT1
CURR:STEP 0.005
CURR:STEP DEF
VOLT:STEP? DEF -> 0.1000E+00
Returns the default stepsize for current.
See also
Example "Configuring the current limit"
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]
<current>
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]?
[<current>]
Sets/Queries the current value of the selected channel.
Setting parameters:
<current>
numeric | MIN | MAX | UP | DOWN
numeric
Numeric value in the range of 0.000 to 6.000.
MIN
Minimum current at 0.010 A.
MAX
Depending on the set voltage level, the maximum set current is
6.000 A.
For voltage range from 0 V to 6 V, maximum set current is 6 A.
For voltage > 6 V, maximum set currernt is 3 A.
UP
Increase current by a defined step size. See
]CURRent[:LEVel][:IMMediate]:STEP[:INCRement]
Configuration Commands