Connecting the sensor
R&S NRP-Z27/-Z37
1169.3870.12
1.10
E-6
Ports and LEDs
The power sensors are connected to the front panel of the R&S NRP-Z5. The ports and LEDs on the
front panel of the R&S NRP-Z5 are shown in Fig. 1-6.
1
–4
Sockets for connecting the power sensors
5
–8
Green LEDs for indicating normal operation
9
–12
Yellow LEDs for indicating faults
Fig. 1-6
Ports and LEDs on front panel
On the rear panel are the ports for power supply, USB host, trigger input and trigger output. The ports
on the rear panel are shown in Fig. 1-7.
1
Trigger output (BNC socket)
2
Trigger input (BNC socket)
3
Plug allowing connection to Rohde & Schwarz measuring instruments (via R&S NRP-Z2) or to
a PC (via R&S NRP-Z4)
4
USB socket (type B) for connection to the USB host (PC or Rohde & Schwarz measuring
instrument without sensor socket)
5
Power supply socket (supplied external power supply unit or alternative power supply (12 V to
24 V/24 W))
Fig. 1-7
Ports on rear panel
