Remote Control Commands
R&S
®
NRPxxS(N)
80
User Manual 1177.5079.02 ─ 10
Example: Moving termination control
Further settings for this example:
●
[SENSe<Sensor>:]AVERage:TCONtrol
MOVing
Every chopper phase is started by a trigger event and lasts the defined aperture time.
During a chopper phase, the trigger synchronization is high (
ON
). Every measurement provides a result. After 2 measurements, when the average
count is reached, settled data are available.
1
3
4
5
2
7
8
6
1 = Start of the measurement cycle
2 = Trigger event
3 = Noninverted chopper phase
4 = Inverted chopper phase
5 = Trigger synchronization
6 = Measurement result before average count is reached
7 = Averaged measurement result after average count is reached
8 = Return to the start of the measurement cycle
Controlling the Measurement
