Connecting the probe
R&S
®
RT
‑
ZM
24
User Manual 1419.3128.02 ─ 05
3.4.4
R&S
RT
‑
ZMA12 tip cable square pin
The R&S
RT
‑
ZMA12 tip cable square pin is used to plug onto pins and make a
connection to the DUT that is easy to plug and remove. It is well suited for creat-
ing contact with soldered in test leads and can be used to plug onto pin strips with
a pitch of 1.27 mm (50 mil).
Bandwidth: up to 6 GHz
MultiMode compatible
Length: 15 cm
Distance range: 1.27 mm (50 mil)
Temperature range: -30°C to +80°C
Measurements with MultiMode
In this configuration, you can measure single-ended, differential and common
mode signals without resoldering the tip cable.
1. Permanently solder both signal leads (P,N) to the DUT.
2. Permanently solder the ground wire (GND) to the DUT.
3. Connect and reconnect your socket head to your measurement point.
Connecting the probe to the DUT
