Connecting the probe
R&S
®
RT
‑
ZM
28
User Manual 1419.3128.02 ─ 05
Bandwidth: up to 16 GHz
Distance range: 0.5 mm to 8 mm (20 mil to
315 mil)
Axial travel: 0.5
mm (20 mil)
Not
MultiMode compatible, the module has no
ground connector.
Replaceable parts, spring-loaded resistor tips
Using the R&S
RT
‑
ZMA30 browser module sets the probe amplifier to DM mode.
Measurements of signals
1.
CAUTION!
The browser module pins are very sharp, handle them carefully.
Insert the pins in the browser module if needed.
2.
NOTICE!
Applying a side load to the browser module can damage the brows-
er’s pins.
Do not apply too much force when browsing. The weight of the probe in your
hand is usually sufficient.
To measure differential signals, connect both pins to the differential pair at the
DUT.
3. To measure single-ended signals, connect the positive pin to the signal and
the negative pin to the ground.
4. Turn the levers to set the pin distance.
Connecting the probe to the DUT
