Operating Basics
R&S
®
RTC1000
24
User Manual 1335.7352.02 ─ 02
●
Depending on the requirements, the UNIVERSAL knob in the Cursor/Menu section
either selects a value, or navigates through menus. The COARSE/FINE key tog-
gles between fine and coarse resolution of the UNIVERSAL knob.
●
The "MENU OFF" key below the softkeys closes the current menu, or switches to
the next higher level.
●
The effect of channel keys depends on the state of the selected waveform:
–
Activate the channel if the channel is off.
–
Selects the channel if the channel is on and the other channel is selected.
–
Switches off the channel if it is selected.
–
If a channel is selected, its key is illuminated. If a channel is on but not
selected, you see the signal on the display, and its key does not light up.
The menus include some navigation elements and usage principles.
●
Press the softkey to select or toggle a value. The selected value is marked in blue.
●
Some functions must be activated and require value selection. Pressing the softkey
toggles between "OFF" and the last set value. Use the UNIVERSAL knob to
change the value.
●
A round arrow in the softkey indicates that the value is set with the UNIVERSAL
knob.
●
A small triangle on the bottom right of a softkey indicates an additional menu level.
●
If additional menu pages are available, the lowest softkey navigates through the
menu pages. The current page is shown in the soft menu.
3.4 Integrated Help
The integrated help shows explanatory text about the selected function. The text in the
help window is dynamically updated when you select another function.
1. To activate the integrated help, press the HELP key in the General section.
The help window opens, and the HELP key lights up.
2. If you no longer need help, press HELP again.
3.5 Signal Display
This chapter describes the display of signals and the available display modes.
3.5.1 Display Settings
► To adjust the display, press the DISPLAY key.
Signal Display
