Signal Generator Settings
R&S
®
SGT100A
81
User Manual 1176.8674.02 ─ 07
The output is based on the waveform file that is loaded. The name of the waveform file
is displayed next to "Load Waveform".
If a multi-segment waveform is loaded, the section "Multi Segment Waveform Options"
is indicated. In this section, the segment to be output is selected.
If no waveform file is loaded, ARB modulation cannot be powered up. "None" is dis-
played next to "Load Waveform". An error message asks the user to load a waveform
file:
"No waveform file loaded. ARB MOD state remains off. Please select a waveform file
to load, before switching ARB MOD state on."
Remote command:
[:SOURce<hw>]:BB:ARBitrary:STATe
Set To Default
Calls default settings. The values are shown in
Table 7-2: Default settings
Parameter
Value
State
Off
Clock Freq.
1 MHz
Trigger Mode
Auto
Trigger Source
Internal
Marker State
Off
Marker Mode
Unchanged
Clock Source
Internal
Remote command:
[:SOURce<hw>]:BB:ARBitrary:PRESet
Waveform Location
Selects the location of the waveform that you want to load.
"Instrument"
The waveform file is located on the instrument's internal memory.
"Local file system"
The waveform file is located on the local computer. In this case, the
waveform is first automatically copied on the instrument's internal
memory and then selected.
Note:
To load a waveform from a USB memory stick (or external hard
disk) plug the stick into the controller PC, select "Waveform Location
> Local file system" and in the "Load Waveform" >"File Select" dialog
navigate to the external drive.
Load Waveform
Calls the "File Select" menu for loading the waveform file.
Baseband
